Mon–Fri 9 AM – 5 PM  ·  Sat 9 AM – 1 PM (Walk-Ins)  ·  9129 111 Ave NW, Edmonton Call 780-471-2100  |  Text 780-471-2105
Home  ›  How Your Car Works  ›  Brakes

Brakes

How your brakes stop you, why they wear, and when to check them.

How it works

Pressing the pedal pushes a piston in the master cylinder, sending brake fluid through the lines to each wheel. Because fluid doesn't compress, the force from your foot arrives multiplied many times, and the brake booster adds more. At each wheel the fluid pushes the caliper piston, clamping the pads against the spinning rotor. That friction turns your car's motion into heat; one hard stop from highway speed can heat rotors to several hundred degrees.

Why it wears

Every stop wears a little pad and rotor. Too much heat warps or glazes rotors, causing vibration. Brake fluid absorbs moisture over time, lowering its boiling point, so old fluid can boil under hard braking and the pedal goes soft (brake fade).

Warning signs

Watch for: Squealing (pads low), grinding (metal on metal), soft or sinking pedal, pulling to one side, vibration when braking.

When to service

Inspect every 20,000 km. Replace fluid every 2–3 years. In Edmonton, clean and lubricate caliper slides yearly, since salt and slush make them seize.

Go deeper: the technical details
Hydraulic multiplication
Pressure is equal throughout the fluid (Pascal's law). A small master cylinder piston and a much larger caliper piston means force multiplies by the ratio of their areas, often 10 times or more, before the booster and pedal leverage add more.
Friction and heat
Braking force depends on clamping force times the pad's friction coefficient (typically about 0.35 to 0.5). All the vehicle's kinetic energy, half its mass times speed squared, becomes heat. Double the speed and you make four times the heat.
Rotors
Vented rotors have internal fins that pump air through them to shed heat. Thicker rotors store more heat before fading. Minimum thickness is stamped on each rotor.
Pads
Organic pads are quiet but wear fast; ceramic pads are clean and quiet with good heat handling; semi-metallic pads grip hard and handle heat best but are noisier and wear rotors faster.
Fluid
DOT 3 boils at about 205 °C new; DOT 4 about 230 °C. After absorbing around 3% water, boiling points drop by roughly 60–70 °C.
ABS
Wheel speed sensors detect a wheel about to lock. The ABS unit pulses pressure to that wheel up to around 15 times a second, so the tire keeps rolling and you keep steering.

General information for typical vehicles. Your owner's manual may call for different intervals. See also our maintenance schedule and warning lights guide.

Need a hand with it?

Hearing a squeal or grind, or does the pedal feel soft? Have us take a look.

Book Call Text Directions