Mon–Fri 9 AM – 5 PM  ·  Sat 9 AM – 1 PM (Walk-Ins)  ·  9129 111 Ave NW, Edmonton Call 780-471-2100  |  Text 780-471-2105
Home  ›  How Your Car Works  ›  Battery & Charging

Battery & Charging

How your car starts, and how it keeps the power coming.

How it works

The battery stores energy chemically and delivers a big burst of current to the starter motor to crank the engine. Once the engine runs, the alternator, driven by the serpentine belt, takes over: it powers everything electrical and recharges the battery. A voltage regulator keeps the system at about 13.5–14.7 volts.

Why it wears

Every charge and discharge slowly wears the battery's plates. Heat in summer speeds up the damage, and cold in winter exposes it, which is why batteries often die on the first cold snap. Alternators wear out their bearings, brushes and diodes; belts crack and stretch.

Warning signs

Watch for: Slow cranking, clicking with no start, dim or flickering lights, battery warning light, corrosion on the terminals, a whining noise from the alternator, or a battery older than 4–5 years.

When to service

Test the battery every fall. Most last 3–5 years in Alberta. Clean the terminals and check the belt yearly.

Go deeper: the technical details
Voltage
A fully charged battery rests at about 12.6 V; 12.2 V is about half charged; under 12.0 V is nearly flat. Running, the system should show about 13.5–14.7 V.
Cold cranking amps (CCA)
The current a battery can deliver for 30 seconds at −18 °C while staying above 7.2 V. At that temperature a battery has only about half its warm-weather power, while a cold engine needs about twice the effort to crank.
Chemistry
Lead plates sit in sulphuric acid. Discharging coats the plates with lead sulphate; charging reverses it. Left discharged, the sulphate hardens (sulphation) and capacity is lost for good. A flat battery can also freeze around −7 °C, while a full one survives to about −55 °C.
Battery types
Flooded lead-acid is the most common. AGM batteries hold the acid in glass mats, handle vibration and deep cycling better, and are required on many start-stop vehicles.
Alternator
Spinning a magnetic field inside copper windings makes AC current; a diode rectifier turns it into DC. A failed diode can drain the battery overnight and cause AC ripple that confuses electronics.
Parasitic draw
Modules, alarms and memory draw a little power with the car off, normally under about 50 milliamps. Anything much higher will flatten the battery over days.

General information for typical vehicles. Your owner's manual may call for different intervals. See also our maintenance schedule and warning lights guide.

Need a hand with it?

Slow crank on a cold morning? Get your battery tested before it leaves you stranded.

Book Call Text Directions