Cooling System
How your engine keeps from overheating, and how it heats your cabin.
How it works
Burning fuel makes far more heat than motion. The water pump pushes coolant through passages in the engine, where it absorbs heat, then to the radiator, where air flowing through the fins carries the heat away. The thermostat stays closed when the engine is cold so it warms up fast, then opens around 90 °C to send coolant to the radiator. The same hot coolant runs your heater core, which is how you get cabin heat.
Why it wears
Coolant additives break down over time, letting corrosion build up inside. Hoses crack, water pumps leak, thermostats stick, and radiators clog.
Warning signs
When to service
Check coolant level and strength every fall. Replace coolant per your maker's schedule, often every 5 years or 160,000 km for long-life coolant. Inspect hoses and the radiator cap yearly.
Go deeper: the technical details
- Pressure raises boiling point
- The system runs at about 15 PSI. A 50/50 coolant mix boils near 106 °C at normal pressure, but around 125 °C when pressurized. A weak radiator cap lets it boil sooner.
- Freeze protection
- A 50/50 mix protects to about −37 °C; 60/40 (coolant/water) to about −52 °C. More than 70% coolant actually protects less and carries heat worse.
- Additives
- Coolant contains corrosion inhibitors that coat metal surfaces. Mixing incompatible types can cause sludge, so use the type your vehicle specifies.
- Thermostat
- A wax pellet expands as it heats, pushing the valve open. Stuck closed means overheating; stuck open means slow warm-up, poor heat and higher fuel use.
- Heat load
- Roughly a third of fuel energy leaves through the cooling system, a third out the exhaust, and only about a third becomes motion.
General information for typical vehicles. Your owner's manual may call for different intervals. See also our maintenance schedule and warning lights guide.
Need a hand with it?
Temperature gauge climbing or weak heat this winter? Let us check your cooling system.